Why is Ra 3.2 the default, and when is it enough?

Ra 3.2 µm is the standard as-machined finish on CNC mills and lathes using sharp tooling. Ra 1.6 is achievable with an extra finish pass and covers the majority of functional sealing and bearing surfaces. Below Ra 0.8, costs rise significantly because grinding, honing, or polishing operations are needed.

What do the standard Ra values mean?

Ra (µm)Surface AppearanceTypical ProcessCost TierCommon Applications
12.5Visible tool marks, roughHeavy roughing cutsLowestNon-contact surfaces, weld prep areas
6.3Obvious tool marks, matteStandard milling/turningLowInternal structure, hidden brackets
3.2Slight tool marks, smooth matteStandard CNC with sharp toolsBaselineGeneral machined surfaces, default finish
1.6Minimal marks, satin feelFinish pass at high feed/speedModerateSealing surfaces, bearing bores, shafts
0.8Very smooth, faint marks onlyGrinding or fine finish passHighDynamic seal seats, precision journals
0.4Nearly polish, directional grainHoning / lappingHighestHydraulic spool bores, medical contact surfaces

Which should you call out: Ra or Rz?

Ra is the arithmetic mean deviation of the surface profile; Rz is the average maximum peak-to-valley height over a sampling length. Ra is the standard callout on most drawings and is what surface roughness comparators and profilometers are calibrated to. Use Rz only if your sealing or fatigue application specifically requires peak-to-valley control.

Which three decisions come before you specify Ra?

  • Call out Ra on functional surfaces only — applying Ra 1.6 to every face of a part adds cost with no benefit
  • Do not default to Ra 0.8 across the drawing; start from Ra 3.2 and tighten only the faces that need it
  • Remember that anodizing, plating, and painting change the final Ra; specify pre-coat and post-coat roughness separately if it matters

How is Ra actually measured?

Portable surface roughness testers (profilometers) drag a diamond stylus across the surface and compute Ra electronically. For Ra 3.2 and 1.6, visual comparator pads are sufficient for shop-floor checks. If your drawing specifies Ra below 0.8, request a profilometer trace with the inspection report.

TruPart Precision is a Dongguan-based ISO 9001 CNC shop that measures and documents surface roughness when specified on the drawing. Picking the right Ra value is one of the highest-leverage choices a buyer can make for both cost and part performance.

Frequently Asked Questions

  • How much more does Ra 0.8 cost compared to Ra 3.2?

    Ra 0.8 costs more because it is bought with machine time: finer feeds, additional tool passes and sometimes grinding or honing. The difference depends on the part, so it is quoted from your drawing rather than from a fixed percentage.

  • If the drawing does not specify Ra, what is the default?

    Most CNC shops default to Ra 3.2 µm on machined surfaces, which is the finish left by sharp carbide tooling at standard feed rates.

  • Does anodizing change surface roughness?

    Yes. Type II anodizing typically adds 5–15 µm of oxide layer, which can increase Ra by roughly 0.2–0.8 µm depending on alloy and anodize thickness.

  • Can visual comparators replace a profilometer?

    For Ra 1.6 and above, visual comparator pads are adequate for production checks; for Ra 0.8 and below, a stylus profilometer gives objective numerical readings.

Need this kind of part machined?

Send a drawing — quote in 48 hours. No minimum order; one piece is fine.